Develop and refine advanced mechanical inspection techniques to solve complex measurement challenges
Qualify and document inspection methods in partnership with Quality Engineering (procedures, work instructions, and evidence of capability)
Collaborate daily with Quality and Manufacturing Engineering to support production readiness and rapid issue resolution
Support evaluation and selection of new metrology equipment and technologies, including ROI, capability, and implementation planning
Maintain metrology equipment and standards; execute 5S and calibration/verification activities as applicable
Provide design-for-inspection input during drawing release, GD&T definition, and development of inspection standards
Cross-train as a Quality Technician and perform routine inspections as needed to support throughput
Summarize, visualize, and present critical dimensional inspection results to technical and non-technical stakeholders
Design and procure inspection fixturing and tooling to enable accurate, repeatable measurements
Requirements
Ability to occasionally lift up to 50 lbs
Perform activities such as typing, standing, or sitting for extended periods of time
Work in a facility that contains industrial hazards including heat, cold, noise, fumes, strong magnets, lead (Pb), high voltage, high current, pressure systems, and cryogenics
Willingness to travel or work required nights/weekends/on-call occasionally
Ready to Apply?
Join Commonwealth Fusion Systems and make an impact in renewable energy